Articles >>

Turbocharger

Category: Term of the day

Turbocharger

A turbocharger is an exhaust-gas driven forced induction device used in internal combustion engines to improve engine performance by forcing compressed air into the combustion chambers, allowing more fuel to be burned, resulting in a larger power output.

A turbocharger consists of a turbine and a compressor linked by a shared axis. The turbine inlet receives exhaust gases from the engine exhaust manifold causing the turbine wheel to rotate. This rotation drives the compressor, compressing ambient air and delivering it to the air intake of the engine.

The objective of a turbocharger is to improve upon the size to output efficiency of an engine by solving for one of its cardinal limitations. A naturally aspirated automobile engine uses only the downward stroke of a piston to create an area of low pressure in order to draw air into the cylinder. Since the number of air and fuel molecules determine the potential energy available to force the piston down on the combustion stroke, and because of the relatively constant pressure of the atmosphere, there ultimately will be a limit to the amount of air and consequently fuel filling the combustion chamber. This ability to fill the cylinder with air is its volumetric efficiency. Since the turbocharger increases the pressure at the point where air is entering the cylinder, and the amount of air brought into the cylinder is largely a function of time and pressure, more air will be drawn in as the pressure increases. The intake pressure, in the absence of the turbocharger determined by the atmosphere, can be controllably increased with the turbocharger.

The application of a compressor to increase pressure at the point of cylinder air intake is often referred to as forced induction. Centrifugal superchargers operate in the same fashion as a turbo; however, the energy to spin the compressor is taken from the rotating output energy of the engine's crankshaft as opposed to exhaust gas. For this reason turbochargers are ideally more efficient, since their turbines are actually heat engines, converting some of the kinetic energy from the exhaust gas that would otherwise be wasted, into useful work. Superchargers use output energy to achieve a net gain, which is at the expense of some of the engine's total output.

Sergyi Way
21.03.2007

www.army-guide.com

Share...
Printable Version Send by email rss favorite Facebook Vkontakte Twitter Google+

Three-axis amphibious armored truck was created in Belarus
20.03.2018

Kazakhstan Paramount Engineering's 8x8 combat vehicle nearing service entry
14.03.2018

Uralvagonzavod has prepared a new tank engine for serial production
29.11.2017

Supacat unveils LRV600 at DSEi Demonstrating LRV flexibility and increased capability in 6×6 configuration
11.09.2017

6.5 L Turbo (Diesel engine)

ISBe 5.9L Turbo (Diesel engine)

Discuss


At present you cannot leave messages. To be able to do this, you should enter by using your name. If you are not registetred, do it now. The registration procedure will take just one minute.
Register